Case study · 10 April 2024

Andover Continuum into Niagara: Two Projects

A proof of concept in two hours on a site with hundreds of controllers, and a combined BMS and energy system set up almost entirely remotely.

Andover Controls had over 100,000 installations worldwide before it merged with TAC and became part of Schneider Electric. Many of those controllers still run well. Here are two recent projects that brought them into Tridium Niagara with our Andover Infinet driver.

A proof of concept in two hours

A large Andover system went into Niagara 4.13: tens of Andover IP controllers and hundreds of field controllers, all talking to several JACE8000s over IP.

The proof of concept took two hours: start Niagara, install the driver, create a station, enter an IP controller’s address, discover the whole controller network, add a few devices, discover their points and histories, put points on sample AHU and VAV graphics, and show the result to the customer.

A BMS and energy system, set up remotely

The second project combined Andover Continuum Infinet controllers with Schneider Electric ION meters, using our Infinet and ION drivers, into one building and energy management system for a corporate client.

Because everything was on IP, most of the setup was done remotely, with little need to be on site and minimal disruption to the client’s operations. Device and point discovery found all the Andover and ION devices and points automatically. The new interface is simple enough that the site team already uses it more than the legacy systems.

See it working

If your clients run legacy Andover systems, a free trial of the Infinet driver is the quickest way to check it on site. It is a cost-effective alternative to replacing equipment that still works.